Anyone else have a snow stage-1? Where is the psi adjust screw?

TopherSho · July 08, 2017, 06:52:37 PM

I assume it is on the boost reference block.. but was unable to see a screw?

Is there a pop-off panel ?

TopherSho · July 08, 2017, 07:24:30 PM

Solved, there is a super Uber tiny hex hole to a tiny little hex screw .. I assume that's it.

StealBlueSho · July 08, 2017, 08:48:15 PM

Everyone likes a tiny hole...so you are probably correct.

Sent from my iPhone using Tapatalk

StealBlueSho · July 08, 2017, 08:49:20 PM

FWIW as I posted that an add for Mama June popped up...

Sent from my iPhone using Tapatalk

TopherSho · July 08, 2017, 09:52:40 PM

Quote from: StealBlueSho on July 08, 2017, 08:49:20 PM
FWIW as I posted that an add for Mama June popped up...

Sent from my iPhone using Tapatalk

Lol, love it

polskifacet · July 09, 2017, 10:10:47 AM

psi of what

TopherSho · July 09, 2017, 02:46:22 PM

Quote from: polskifacet on July 09, 2017, 10:10:47 AM
psi of what

The basic stage one runs off of a boost reference line, it feeds to the block which is adjustable. It has a hex shaped adjuster that turns the sensitivity up or down. it sense boost pressure.

polskifacet · July 09, 2017, 03:44:36 PM

Quote from: TopherSho on July 09, 2017, 02:46:22 PM
Quote from: polskifacet on July 09, 2017, 10:10:47 AM
psi of what

The basic stage one runs off of a boost reference line, it feeds to the block which is adjustable. It has a hex shaped adjuster that turns the sensitivity up or down. it sense boost pressure.

right because the same exists on the pump (i have a snow stage 1 basically). Factory setting pump psi is 260-280 psi.