CD slot cell phone holders

[Scott13SHO]

I had one for my 2013 SHO-but the fit was on the sloppy side. I’d like to get one that fits better and has a magnetic head on it told me over till I get a 2021 Bronco with Sync3 or whatever they are gonna call it then


Sent from my iPhone using Tapatalk

 

[Scott4957]

I personally would avoid it. I have one in my 2013 MKS and for the life of me I can't get it out without feeling like I'm going to break something. I don't use the CD player but it seems fused in there after a couple years.

 

[glock-coma]

Ive been using this for the better part of 2 years without issue.
I actually have the older version that had a yellow magnetic area.
I added a couple of neodymium magnets to increase the holding power.
The extra magnets are not really necessary with just a phone only tablets.


Mountek nGroove Snap+ HeavyDuty Magnetic CD Slot Car Mount for Cell Phones, Smartpho... https://www.amazon.com/dp/B00R0MELU6/ref=cm_sw_r_sms_c_api_udTLBb8Z6S33X

 

[Scott13SHO]

Does anyone know if these magnetic holders will wipe out credit card strips? I have a wallet case on mine


Sent from my iPhone using Tapatalk

 

[glock-coma]

Does anyone know if these magnetic holders will wipe out credit card strips? I have a wallet case on mine


Sent from my iPhone using Tapatalk

Yes, neodymium magnets in close proximity to the credit card strip will erase or scramble data.
Cell phone case wallets and magnetic phone mounts are not a recommended combo.

Here’s some good reading.
https://www.kjmagnetics.com/blog.asp?p=magnetic-stripes

 

[Scott13SHO]

Does anyone know if these magnetic holders will wipe out credit card strips? I have a wallet case on mine


Sent from my iPhone using Tapatalk

Yes, neodymium magnets in close proximity to the credit card strip will erase or scramble data.
Cell phone case wallets and magnetic phone mounts are not a recommended combo.

Here’s some good reading.
https://www.kjmagnetics.com/blog.asp?p=magnetic-stripes

That was perfect! Thought it begs the question if the metal plate it attaches to will be enough to block the magnet. The one I picked up has a few plates and I was thinking about putting it the closest the outside part of the case so I can use it when I want to (the cards in a rubber case material on the back)

 

[glock-coma]

Yeah, they say 1/32-1/16” “should”
be enough the block it but idk.

 

[Macgyver]

As far as the slot. Mine was lose too even with all they supplied adjusters. I just used some thin black foam tape I had laying around and it works like a charm.