My AJP Meth experience

[TopherSho]

He did up the boost from 14.0 to 14.5, then pulled some throttle control, and upped the spark a couple degrees.. 

I'm very surprised by the throttle behavior.  I do not remember it bouncing like that in previous builds. 

Brad's looking it over later when he has time..

I bought 4 bottles of heat and mixed in two into the 3-quart Rez.. I may do an additional run and see if that persists.

It has felt off since coming back from my 3 week vacation...Not sure what's up yet.

 

[DerricksSho]

Ive been debating on using meth for a while what kit did you use and have you thought about dual injectors or direct injection or is your setup what most are running thanks?

 

[TopherSho]

Ive been debating on using meth for a while what kit did you use and have you thought about dual injectors or direct injection or is your setup what most are running thanks?

Snow's stage 1 kit
it is not a progressive kit,  it just spews 100% as soon as it is enabled.  single nozzle of 375ml about 5 inches from the throttleblade in the hot-pipe!

 

[StealBlueSHO]

Has he changed the throttle response on your tune? He changed mine and not sure why....


Sent from my iPhone using Tapatalk

 

[TopherSho]

Has he changed the throttle response on your tune? He changed mine and not sure why....


Sent from my iPhone using Tapatalk

Noooo idea.  AJP comment ?

 

[StealBlueSHO]

Has he changed the throttle response on your tune? He changed mine and not sure why....


Sent from my iPhone using Tapatalk

Noooo idea.  AJP comment ?

I pinged him in an email. Obviously he has been crazy busy the past couple weeks, but he said we can address it when he gets a chance. I know he was working on a way to smooth delivery of all the low end boost off the line. Maybe thats it.. 

 

[TopherSho]

Has he changed the throttle response on your tune? He changed mine and not sure why....


Sent from my iPhone using Tapatalk

Noooo idea.  AJP comment ?

I pinged him in an email. Obviously he has been crazy busy the past couple weeks, but he said we can address it when he gets a chance. I know he was working on a way to smooth delivery of all the low end boost off the line. Maybe thats it..

cool,  so far I do not have traction issues except for shifting.

 

[lamrith]

cool,  so far I do not have traction issues except for shifting.

You breaking loose on shifts now?

 

[DerricksSho]

Ive been debating on using meth for a while what kit did you use and have you thought about dual injectors or direct injection or is your setup what most are running thanks?

Snow's stage 1 kit
it is not a progressive kit,  it just spews 100% as soon as it is enabled.  single nozzle of 375ml about 5 inches from the throttleblade in the hot-pipe!

Thanks.. Brad (AJP) will more than likely be next in long line of tuners to tune my SHO.
The thought of Meth is really starting to sound nice coupled with E-85 how well does it work?

 

[StealBlueSHO]

Ive been debating on using meth for a while what kit did you use and have you thought about dual injectors or direct injection or is your setup what most are running thanks?

Snow's stage 1 kit
it is not a progressive kit,  it just spews 100% as soon as it is enabled.  single nozzle of 375ml about 5 inches from the throttleblade in the hot-pipe!

Thanks.. Brad (AJP) will more than likely be next in long line of tuners to tune my SHO.
The thought of Meth is really starting to sound nice coupled with E-85 how well does it work?

I threw a little E85 into my LMS meth tune as it tends to produce a small amount of knock retard deep into third once in awhile (like +1 at most) and it staves it off. Hawkeye has an E30/meth tune from BCB...

It's pretty common place to throw E in with meth. I  suspect it works well.

Me personally don't want to need to rely on 3 types of fuel...


Sent from my iPhone using Tapatalk

 

[TopherSho]

cool,  so far I do not have traction issues except for shifting.

You breaking loose on shifts now?

I was before when the IAT2 was @ or under 100f.  now it just does it all day long on a WoT in 1st to 2nd.  to be more detailed this is not a 'spin' or burnout in 2nd though, more a quick front driver hop-hop-hop and it regains full traction.  the rears never skip/hop.

 

[TopherSho]

Ive been debating on using meth for a while what kit did you use and have you thought about dual injectors or direct injection or is your setup what most are running thanks?

Snow's stage 1 kit
it is not a progressive kit,  it just spews 100% as soon as it is enabled.  single nozzle of 375ml about 5 inches from the throttleblade in the hot-pipe!

Thanks.. Brad (AJP) will more than likely be next in long line of tuners to tune my SHO.
The thought of Meth is really starting to sound nice coupled with E-85 how well does it work?

I threw a little E85 into my LMS meth tune as it tends to produce a small amount of knock retard deep into third once in awhile (like +1 at most) and it staves it off. Hawkeye has an E30/meth tune from BCB...

It's pretty common place to throw E in with meth. I  suspect it works well.

Me personally don't want to need to rely on 3 types of fuel...


Sent from my iPhone using Tapatalk

I am already annoyed at the 3-quart tank in the snow kit.  a third fuel type would make me cranky!

 

[TopherSho]

Ive been debating on using meth for a while what kit did you use and have you thought about dual injectors or direct injection or is your setup what most are running thanks?

Snow's stage 1 kit
it is not a progressive kit,  it just spews 100% as soon as it is enabled.  single nozzle of 375ml about 5 inches from the throttleblade in the hot-pipe!

Thanks.. Brad (AJP) will more than likely be next in long line of tuners to tune my SHO.
The thought of Meth is really starting to sound nice coupled with E-85 how well does it work?

If you mean meth tune on top of a E-tune it is a world of awesome. 

You will get the best of both worlds.  Fast high spark launch (which i do not get on pump-92) and then a bunch more spark like 750MS later ..

Your 0-60ft will improve slightly and then you will gain all the TQ from the extra points of spark the meth will provide + cold IAT2 temps to keep your ECU out of the spark penalty box all the way through the run.

 

[TopherSho]

Update:  a minor hiccup in my meth experience i wanted to share because someone else will see it eventually, and i like to overshare stuff

Disclaimer! : Up front .. I am not even close to thinking this is a tune issue.  So I had a bit of a conundrum about posting it in this thread.  But posting a new thread seemed spammy.. so I will post it here.

What I am noticing recently is after the car sits for 8+ hours.. there is a meth hiccup under sustained load for the first few meth-pushes (IE i call a meth push a short burst of meth.. say 0-60 where the meth is on for like 3 seconds.). 

I reproduced it in In a 3rd gear sweep and logged it.  I feel the car is not pushing full spark and it feel sluggish until about 4000rpm  and then there is power fluctuation (like a stutter.. but it is NOT a stutter), then it goes full spark and jumps in massive power. 

if i do a back to back 3rd gear sweeps THE SECOND PASS does not do the same thing and it feels stupid powerful from the start.

i logged and attached it.

now my theory is this:
--I do not have a check valve and it is getting air pushed into the line, and I am getting air bubbles on the first few pushes until the line is purged.  this disrupts the meth, etc.    this makes the most sense.  the line is subjected to 5=6 pounds of boost all the time and no meth flow is occurring.  in my head over time the crack-pressure rating on the pump itself is not going to prevent air from pushing into the line.  i plan on testing this eventfully by draining the meth and running water through with the collar outside the vehicle

--i have a nozzle issue.. maybe.. but to me it would happen all the time.  but if i do it will be evident in the external test

--bad meth,  i had a batch go bad.  i somehow contaminated the VPdrum. i have been adding HEET to try to not waste what i had. i now have a full new drum and will see if new meth helps.  maybe the bad meth was separating ?

anyhoo.  sharing is caring.. someone might run into it ...

 

[TopherSho]

Update:  a minor hiccup in my meth experience i wanted to share because someone else will see it eventually, and i like to overshare stuff

Disclaimer! : Up front .. I am not even close to thinking this is a tune issue.  So I had a bit of a conundrum about posting it in this thread.  But posting a new thread seemed spammy.. so I will post it here.

What I am noticing recently is after the car sits for 8+ hours.. there is a meth hiccup under sustained load for the first few meth-pushes (IE i call a meth push a short burst of meth.. say 0-60 where the meth is on for like 3 seconds.). 

I reproduced it in In a 3rd gear sweep and logged it.  I feel the car is not pushing full spark and it feel sluggish until about 4000rpm  and then there is power fluctuation (like a stutter.. but it is NOT a stutter), then it goes full spark and jumps in massive power. 

if i do a back to back 3rd gear sweeps THE SECOND PASS does not do the same thing and it feels stupid powerful from the start.

i logged and attached it.

now my theory is this:
--I do not have a check valve and it is getting air pushed into the line, and I am getting air bubbles on the first few pushes until the line is purged.  this disrupts the meth, etc.    this makes the most sense.  the line is subjected to 5=6 pounds of boost all the time and no meth flow is occurring.  in my head over time the crack-pressure rating on the pump itself is not going to prevent air from pushing into the line.  i plan on testing this eventfully by draining the meth and running water through with the collar outside the vehicle

--i have a nozzle issue.. maybe.. but to me it would happen all the time.  but if i do it will be evident in the external test

--bad meth,  i had a batch go bad.  i somehow contaminated the VPdrum. i have been adding HEET to try to not waste what i had. i now have a full new drum and will see if new meth helps.  maybe the bad meth was separating ?

anyhoo.  sharing is caring.. someone might run into it ...

additional note.  in the log.. the 3rd pull is the most clear and evident.  you can see the STFT drop BEFORE the shelf of TQ and Timing hits all at once.  so it was pushing meth, but not liking it or there was a flow issue (air?)..

 

[StealBlueSHO]

Agree... the first two pulls look OK.. the first one you picked up +3.5 KR initially so depending on how aggressive Brad has your tune pulling spark based on KR that could be the reason it felt off the first time? The second time everything looks fairly normal. The third pull I see what you mean.. its like the juice wasn't spraying initially.. but it would be interesting since you were just spraying a few moments before? I dunno..

I usually don't do my third gear pulls that low in the RPM band.. usually I start around 3500rpms so unfortunately I am not sure what spark is supposed to look like that low with the pedal requesting max torque.

What PSI do you have your meth kicking on at?

I agree.. something funky..

EDIT: Attached are a couple older 3rd gear pull where I started low... something to compare with..

 

[TopherSho]

I'm on the adjustable pressure trigger not a digital trigger.  So I have no actual idea.  I just set it so that I don't spray meth on normal driving unless i push past say 30% pedal.

if i guessed it turns on around 6-pounds based on feedback from SNOW support techs. 

It was operating normally prior to vacation,  then after i noted the behavior.

I am going to the drags tonight at PIR,  I will keep a eye on it but I expect to to behave.  After the drags I will be off mixing and on pure meth.

so test #1 will be to see if the issue persists with pure meth
test #2 will be to put water in the tank and flush it all and then let it sit and pull the collar and jump the switch and see if i see spurts that resolved after a few seconds.

 

[StealBlueSHO]

I'm on the adjustable pressure trigger not a digital trigger.  So I have no actual idea.  I just set it so that I don't spray meth on normal driving unless i push past say 30% pedal.

if i guessed it turns on around 6-pounds based on feedback from SNOW support techs. 

It was operating normally prior to vacation,  then after i noted the behavior.

I am going to the drags tonight at PIR,  I will keep a eye on it but I expect to to behave.  After the drags I will be off mixing and on pure meth.

so test #1 will be to see if the issue persists with pure meth
test #2 will be to put water in the tank and flush it all and then let it sit and pull the collar and jump the switch and see if i see spurts that resolved after a few seconds.

Good luck at the drags! BTW... looking at your IATs and STFT it appears that your widebands start picking up the extra fuel at 8.2PSI.. so you are probably starting you spray around 7 or so.. pretty close.. It takes a second for everything in the ECU to start picking up the changes.

 

[TopherSho]

Understood.  thank you!

I am excited.  this will be a 12's night for sure.  keeping my fingers crossed for GOOD 12's though ,  my 60ft is not very likely to go down much so it is going to come down to how much power i put down past 2nd gear. 

 

[TopherSho]

I got a 12 6 9 my 60-foot is still really crappy so I just drop the tire pressure to 30 lb and we'll see what happens now