Oil feed line replacement

[Txstrmhntr]

My turbo oil feed line to the rear turbo was really brittle on the braided nylon piece, from what I'm guessing is the heat generated in that area. It cracked while I was either installing our removing it while putting my atps in. I'm currently heading up to a hydraulic repair shop and they are going to custom fab me stainless braided lines for front and back turbos I'll update with pics when done

 

[SHOdded]

Sorry to hear about the feed line, good luck on the upgrade, and looking forward to pics

 

[SHOnUup]

Best of luck on the fix. Actually sounds like a nice upgrade. I bet some of us around here would be interested in some of these also.

Rich

 

[Txstrmhntr]

It's actually fairly simple. -4An braided line, m10 to -4 fitting into block, cut the stainless tube on the turbo install a -4 fitting there and screw the braided line of desired length in

 

[Txstrmhntr]

 

[SHOdded]

New line?  That was quick!  Looks good, how much did it run you?

 

[Txstrmhntr]

$32, only did the rear I need to take some better measurements for the front to make sure on fitament

 

[SHOnUup]

Cool stuff

Rich

 

[bpd1151]

Very nice upgrade for sure.

Oughta add some well deserved piece of mind at the minimum.

Which that, in itself, is priceless.

 

[Txstrmhntr]

And relatively low cost piece of mind, I'm going to change the front turbo oil feed, and my meth tank to pump lines with this as well,

 

[SHOdded]

Gonna look sweet!!!

 

[Txstrmhntr]

Installed, was just a tad longer than I wanted but works well didn't have to bend it to sharply.

 

[SHOdded]

NICE!