Bolt torque specs for front and rear transmission mounts?

[10ECOMKS]

Anyone have this info that could pass along?

 

[ridered74]

Mine came with that info. If I remember right it was 80 ft/lbs. Been awhile tho so I could be wrong. Weird that you didn't get that info with yours.

 

[10ECOMKS]

Mine came with that info. If I remember right it was 80 ft/lbs. Been awhile tho so I could be wrong. Weird that you didn't get that info with yours.

Thanks ridered74. I should be getting my set this Friday. I wasn't sure if they would come with the torque specs or not, so I wanted to ask ahead of time. I didn't recall seeing anyone post it and I'm a stickler when it comes to proper torquing.

 

[sm105k]

I went with 4 ugga duggas.

 

[10ECOMKS]

I went with 4 ugga duggas.

4 ugga duggas seems about right...... With the correct number of beers consumed and properly correlated calibration of ugga dagga, that should work out to exactly 80ft/lbs.  :biggrin:

 

[sm105k]

I went with 4 ugga duggas.

4 ugga duggas seems about right...... With the correct number of beers consumed and properly correlated calibration of ugga dagga, that should work out to exactly 80ft/lbs.  :biggrin:

My man!

 

[ridered74]

I've been racking my brain trying to remember, but I'm old as dirt so that didn't go well. I feel like it was either 80 or 105 but I didn't save the instructions and don't remember for sure. If yours don't come with the specs I would try 80 first and if there is a lot of NVH maybe tighten it up to 105. Pretty sure 80 is 2 ugga duggas and 105 would be right about 4 ugga duggas.

 

[10ECOMKS]

I've been racking my brain trying to remember, but I'm old as dirt so that didn't go well. I feel like it was either 80 or 105 but I didn't save the instructions and don't remember for sure. If yours don't come with the specs I would try 80 first and if there is a lot of NVH maybe tighten it up to 105. Pretty sure 80 is 2 ugga duggas and 105 would be right about 4 ugga duggas.

Thanks for your input ridered74. Mine didn't come with torque specs, so I torqued them to 80ft/lbs. ...It felt right. It didn't take much to brake the bolts loose

 

[10ECOMKS]

For anyone interested...the factory torque spec for the (4) 15mm front and rear mount bolts is 66ft/lbs on the frame sides (farthest forward and farthest rear) and 76 ft/lbs for the bolts that are on the engine/transaxle sides of the mounts.

 

[avidmotion]

....miss placed uggga torque wrench, but is it 80 lbs then for the 2nd gen AD mounts?

 

[avidmotion]

Anyone have torque specs on the 2nd gen AD wishbones?

 

[avidmotion]

Ok then.....ill try 80 lbs.....