Need help locating the fuel pressure sensor on my 2013 SHO...
- Thread starter ddlopes
- Start date
Are you looking for the Fuel Rail Pressure Sensor? It is located underneath the Intake Manifold
Removal and Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.
Release the fuel system pressure. For additional information, refer to Section 310-00 .
Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
Remove the intake manifold. For additional information, refer to Section 303-01B .
Disconnect the Fuel Rail Pressure (FRP) sensor electrical connector.
Remove the FRP sensor.
* To install, tighten to 33 Nm (24 lb-ft).
To install, reverse the removal procedure.
Removal and Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.
Release the fuel system pressure. For additional information, refer to Section 310-00 .
Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
Remove the intake manifold. For additional information, refer to Section 303-01B .
Disconnect the Fuel Rail Pressure (FRP) sensor electrical connector.
Remove the FRP sensor.
* To install, tighten to 33 Nm (24 lb-ft).
To install, reverse the removal procedure.
I have paid for the manual, probably infringing on copyright, but so be it, till they tell me to cease & desistddlopes said:
EBay has offers for manuals on CD/DVD, I think under $15, pretty darned close to free. Or you can subscribe to online services from Motorcraft, AllData, Chiltons etc for your specific year. Motorcraft of course is up to date with the latest everything for every MY, but AllData/Chiltons only go up to 2014/2015 MY I think. Not a biggie, but some small changes DO happen from MY to MY that can trip you up.