What have you done to your Ecoboosted vehicle today?

[DJE624]

That looks great 68!

 

[68_GT]

thanks guys I just ordered all the other LED bulbs for the car, puddle lights, interrior etc...now I wish I could find the thread I saw about putting a brighter LED bulb in the front lower LED strip / fog / parking light.

anyone know where that is ?????????

 

[SRT82ECOBOOST]

Picture of the debadging(night shot):

 

[SHOdded]

Very clean, SRT82!

 

[68_GT]

Picture of the debadging(night shot):

I like it maybe add a back Lincoln ecoboost badge where the SHO / eco badge was before ?? looks clean, but a little naked ? I thnk the black ecoboost badges look clean and tough. That's probably what I'lll put on my tuxedo black '13.

 

[SRT82ECOBOOST]

I really like a lack of badging on my cars, especially since it says AWDSHO on my plates. Wish I could also find a way to get ride of the big only SHO badge on the front quarter panels.

 

[DJE624]

Looks nice SRT8! 

 

[SHOdded]

Maybe you can plastidip or paint them white to minimize the impact?  Or take the fender badging and have blanks made up at a machine shop?

 

[SRT82ECOBOOST]

Maybe you can plastidip or paint them white to minimize the impact?  Or take the fender badging and have blanks made up at a machine shop?

I am really thinking about the white plastidip.

 

[SHOdded]

I don't know if they have gloss white, but they do have a glossifier product also.

 

[TSS]

I really like a lack of badging on my cars, especially since it says AWDSHO on my plates. Wish I could also find a way to get ride of the big only SHO badge on the front quarter panels.

`

You mean the vents?  If so, then just buy some pre 2013 vents and pop them in.  Or are you talking about something else?

 

[TSS]

Picture of the debadging(night shot):

I like it maybe add a back Lincoln ecoboost badge where the SHO / eco badge was before ?? looks clean, but a little naked ? I thnk the black ecoboost badges look clean and tough. That's probably what I'lll put on my tuxedo black '13.

If you decide to go that route, I have one (new Lincoln black ecoboost badge)advertised in the for sale section here. 

 

[SD13SHO]

Well, I covered the Ford name on the front emblem and the steering wheel with SHO decals in Red and Silver.  I will see how they hold up over the winter. I received three decals, two for the outside Ford emblems and one for the steering wheel, at a cost of $19.95, free shipping.  If you show your car, you may not want these, as the word Ford does show through on close inspection. It is a shadow behind the SHO. I can live with this as I don't plan to show the car. Hopefully the photos will post..

 

[mhenne4]

Picked up a set of 4 BF Goodrich sport comp 2 tires.

They will go on Thursday!

 

[bpd1151]

SD13SHO.... those don't look too shabby now.

I also like that faux wood grain interior you're sport'n. k:

Ok, so for my SHO today, I received all of the clamps, and silicone hoses for my hard/hot pipe order.

4DR says my pipes will likely ship out by week's end. No promises though.

So i'll have to arrange for powder coat hopefully by this time next week, or perhaps the following week after that.

Then install time.

Sent from my DROID3 using Tapatalk 2

 

[SD13SHO]

Thanks bpd1151…The wood grain is the real deal..no fake wood here 

 

[DJE624]

I like the woodgrain too.  Do you have any more pics?  Like the console maybe?

 

[EcoBrick Bob]

I put real- wood in both my G8's.  It has a 3M backing and is available in around 8-10 variations of real wood veneer.  I would use it in Flex except they cut out the "Flex" logo above the glove box, and I have removed that logo and don't want to replace.  Fake wood in Flex leaves much to be desired...

 

[BiGMaC]

EB... pics please, and a URL if there is one.  TIA

 

[SD13SHO]

To DJE624…here you go.  I did not use the pieces for the dash as I like the original silver. I just used the small trim pieces below. There are are surrounds for the door switches, and the back of the center console.