What have you done to your Ecoboosted vehicle today?
- Thread starter 4DRHTRD
- Start date
irondoor19
New member
OK:
I WANT TO SAY THANK YOU TO ALL THAT HAVE DONE THE PTU GEAR OIL CHANGE:
For without your write ups IT would have taken FOREVER[/b], SO 35K miles on the Car
I got it with 25K, so 10K hard Miles by me, If you drive hard Change it at 25K..
Got out About 12 OZ Total + 2 on the Floor), Added 16 OZ in Approx
USED the Bulb Pump, that it looks like everyone is using (another PITA).
It would not Draw Tru, until We Heated the Case with a Propane Torch (used map Gas)
and after about 10 Min of Even Heat on the case bottom, the flow was Good.
Cut the Hose Length on both Ends (more on the oulet), tyewrapped to the exhaust.
Next time i will cover the outlet hose with a piece of copper to make it straiten out.
Drove about 2 Blocks, then on the Freeway for WOT.
You could feel the Difference Right away, and the Thing Rolls MUCH Smoother,
NO Binding (smooth as the top of my Head). will do it again after 3 Months ;D
I WANT TO SAY THANK YOU TO ALL THAT HAVE DONE THE PTU GEAR OIL CHANGE:
For without your write ups IT would have taken FOREVER[/b], SO 35K miles on the Car
I got it with 25K, so 10K hard Miles by me, If you drive hard Change it at 25K..
Got out About 12 OZ Total + 2 on the Floor), Added 16 OZ in Approx
USED the Bulb Pump, that it looks like everyone is using (another PITA).
It would not Draw Tru, until We Heated the Case with a Propane Torch (used map Gas)
and after about 10 Min of Even Heat on the case bottom, the flow was Good.
Cut the Hose Length on both Ends (more on the oulet), tyewrapped to the exhaust.
Next time i will cover the outlet hose with a piece of copper to make it straiten out.
Drove about 2 Blocks, then on the Freeway for WOT.
You could feel the Difference Right away, and the Thing Rolls MUCH Smoother,
NO Binding (smooth as the top of my Head). will do it again after 3 Months ;D
But might not be a bad idea to just fill it back up to max level for now, run it around awhile before trying it again.Vortech347
New member
Haven't done it yet but debating on doing some 1/4" spacers to push my wheels out a bit further and fill the fenders. If necessary I'll change the studs out too, that's easy. The rear's are just tucked so far in. Looks goofy.
irondoor19
New member
Installed Tire Rack Wall Storage Rack,
Mounted and Balanced Tires, Covered Em,
Loaded them in the Rack, "what a pain",
But NOW Ready for Spring Race Season
Waiting to Scrub another 3-5K off the Stock Tires,
(till the Cord is showing, HA) and NO MORE Snow "Please"
Mounted and Balanced Tires, Covered Em,
Loaded them in the Rack, "what a pain",
But NOW Ready for Spring Race Season
Waiting to Scrub another 3-5K off the Stock Tires,
(till the Cord is showing, HA) and NO MORE Snow "Please"
66 Galaxie
New member
Nice mod and congratulations!
Got er almost ready for spring and a trip to Mississippi, washed, clay barred, waxed, cleaned inside and engine. Loaded a ton of new wallpapers in the sync system (so easy I wish I woulda did it sooner) and thinking about throwing the TSW's on because why not have it looking badass while taking a trip. See if I can sell people on some flexes while driving. Hahaha. Oh and re did the hot pipes I got that have the Tial blow off valve. Haven't had em on yet but waiting on a new part to try that is made for the f150 Eco to see if it'll work.
Did in cast grey. Red just wasn't doing it for me.
Did in cast grey. Red just wasn't doing it for me.
